Completed scheduled recurring maintenance visit on two 4-year-old HVAC systems. Performed comprehensive cooling system inspection, accessed internal components to verify electrical connections and wiring integrity, and confirmed both units are operating within normal parameters with all systems functioning properly.

Responded to service call for main drain line blockage. Upon arrival, accessed cleanout in basement utility area and assessed drainage system. Customer reported suspected clog in main line before connection to street. Performed initial inspection of accessible drain lines and cleanout access points. Documented existing plumbing configuration including PVC drainage system and basement utility setup for potential camera inspection if blockage persists or recurs.

Responded to service call for sump pump running continuously. Upon arrival, conducted diagnostic inspection of sump pump system and exterior discharge line. Verified proper operation of discharge piping, checked for potential obstructions or frozen discharge lines, and assessed float switch mechanism for proper cycling functionality to resolve continuous running condition.

Replaced existing shower valve with Moen Eva T2133 trim kit, ensuring proper water flow and temperature control. Installed American Standard Champion one-piece toilet, including setting new wax ring, securing flange connection, and verifying proper seal and flush operation.

Responded to multiple drain blockages throughout a 20-year-old residence affecting bathroom sink, toilet, dishwasher, and shower. Upon arrival, performed systematic assessment of all affected fixtures to determine extent and location of clogs. Inspected main water supply lines and plumbing infrastructure in utility closet, noting copper piping with existing shut-off valves and flow control devices. Verified water pressure and supply functionality to rule out main line issues. Assessed condition of visible plumbing connections and support brackets. Cleared bathroom sink drain using appropriate augering techniques to remove accumulated debris and buildup. Addressed toilet blockage through mechanical snaking, successfully restoring proper flush and drainage function. Cleared shower drain obstruction, removing hair and soap residue buildup that had accumulated over time. Investigated dishwasher drainage issue, checking air gap, drain hose routing, and connection to garbage disposal or

Responded to service call for sink faucet replacement at a 32-year-old residential property. Upon arrival, assessed the existing plumbing fixtures and determined the bathtub spout required replacement rather than a sink faucet. Removed the old chrome bathtub spout and diverter assembly, inspected the copper stub-out for proper thread condition and corrosion, and installed a new chrome-finished tub spout with integrated diverter mechanism. Verified proper water flow and diverter operation, checked for leaks at the connection point, and confirmed all components were securely mounted. Also noted evidence of previous water intrusion visible on the ceiling surface near the bathroom area, which may require future monitoring. All plumbing fixtures tested and left in proper working condition.

Completed final installation phase of ductless mini-split air conditioning system by concealing refrigerant line set and electrical conduit. Installed exterior line hide cover along building exterior wall, securing two vertical white PVC chase sections to conceal refrigerant lines running from ground level to the wall-mounted indoor air handler unit, ensuring professional appearance and protection of refrigerant piping from environmental elements.

Responded to emergency no-water situation caused by failed main water line. Upon inspection, identified compromised mainline with significant corrosion, mineral buildup, and deteriorated pipe connections in the basement plumbing assembly. The existing copper piping system showed advanced oxidation with greenish patina and brown discoloration throughout multiple connection points. Main shutoff valve and brass valve body connections exhibited extensive aging and white mineral deposits indicating long-term water quality issues. Conducted camera inspection of main sewer/water line opening, revealing heavy sediment accumulation, rust-colored deposits on threaded couplings, and corroded metal components. The pipe interior showed significant scaling and debris buildup affecting water flow capacity. Assessed the threaded connection points which displayed severe corrosion requiring immediate replacement to restore water service. Performed mainline repair by replacing damaged sections of pipin

Conducted comprehensive site evaluation for complete furnace and air conditioning system replacement. Assessed existing HVAC infrastructure including exterior disconnect box, refrigerant line set with brass flare connections, basement ductwork labeled for second floor zoning, and Honeywell humidifier integration to provide accurate equipment sizing and installation specifications for replacement estimate.

Replaced defective control board and gas valve on HVAC unit to restore proper system operation. Installed new components, verified all electrical connections at terminal blocks, and tested system performance with digital measurement equipment confirming proper readings at 52.3 units. Unit returned to full operational status with all safety controls functioning correctly.

# HVAC System Conversion and Installation Successfully completed a comprehensive system conversion from electric to natural gas heating, including installation of a complete HVAC system with all necessary components and infrastructure. Installed a new 90% AFUE gas furnace as the primary heating unit, replacing the existing electric heating system. The furnace was properly positioned in the basement utility area with appropriate clearances and mounted securely. Connected high-efficiency PVC venting system, routing condensate drainage and exhaust piping through the ceiling structure to exterior termination points in compliance with manufacturer specifications and local code requirements. Installed a new air conditioning condenser unit on the exterior of the residence, positioning it on a vibration-dampening rubber pad in the landscaped area adjacent to the home. Completed all electrical connections including dedicated circuit wiring, disconnect box, and proper grounding. Ran refrigera

Installed two dedicated 110V electrical circuits to support HVAC and water heating systems. First circuit powers the furnace unit, while the second circuit serves the power vent assembly for the water heater. Routed electrical wiring through exposed wall studs and ceiling joists, securing all conduit and cabling per code requirements. All connections completed and circuits tested for proper operation.

# Main Drain Cleanout Service Responded to service call for plumbing drainage issue in residential property. Upon arrival, accessed utility room to locate and assess main drain cleanout system. Inspected exposed plumbing infrastructure including copper supply lines, shut-off valves, and drainage piping throughout mechanical space. Performed main drain cleanout procedure to address reported drainage concerns and restore proper flow through the system. Documented existing plumbing configuration and conditions via photographs for service records. System tested and verified operational upon completion of cleanout service.

# Service Summary Completed AC circuit installation with 480V power wiring as part of rescheduled service call. Work performed in residential storage/utility area with successful circuit integration and testing to restore proper electrical function.

# Plumbing Service Report - Main Sewer Stack Repair Technician successfully completed repair of a leaking section on the main sewer stack. The damaged portion of the stack was cut out and replaced with new PVC pipe and fittings. The existing clean-out T-fitting was removed and replaced with a WYE connection oriented in the opposite direction to provide proper access point for future main line snaking operations if needed. All connections were properly fitted and secured according to code specifications. Upon completion of the installation, the entire repaired section was pressure tested to verify system integrity and confirm no leaks were present. The repair passed testing successfully with no leaks detected. Required parts were ordered and received at the shop prior to service completion. Wall access was created to reach the affected plumbing, and photographic documentation of the work area and completed repair was captured for service records.

Successfully installed new 50-gallon electric tall water heater in utility area with proper connections to existing copper pipes. Installed unit on appropriate drain pan with PVC drain pipe connected to floor drain, and installed expansion tank as required. All connections were tested and verified for proper operation prior to completion.

Diagnosed furnace issue where unit was blowing cold air; identified faulty capacitor as the root cause. Removed and replaced defective capacitor, restoring proper heat function. Verified system operation through complete heating cycle and confirmed all connections secure before completing service.

Diagnosed and repaired leaking shower valve that was preventing proper water shutoff. Installed new fixture and tested for proper operation. Water service to shower and connected appliances has been restored and is functioning normally.

Successfully replaced a 16-year-old fifty-gallon electric water heater in residential property. Installation was completed in utility room/basement area, with proper connection to existing copper piping and verification of system functionality. New unit installed with appropriate energy efficiency rating as evidenced by Energy Guide labeling.

Completed installation of main gas line with appropriate appliance stub-outs, valves, and caps to prepare for gas meter installation. System includes both 1/2" and 3/4" BI pipe components as specified in the service plan. Installed and pressure-tested the system to ensure proper sealing for upcoming gas company inspection and meter installation.