HVAC, Plumbing & Electrical in Cuyahoga Falls, OH

Conducted on-site evaluation of existing sump pump system to provide estimate for battery backup installation. Assessed current sump pump configuration, including discharge piping, electrical connections, and basin setup to determine compatibility and requirements for backup power system integration.

Completed installation of new air conditioning system including outdoor condensing unit and evaporator coil. Replaced failed contactor showing heat damage and discoloration on copper terminals with new 25A rated component. System installed against exterior wall with proper electrical disconnect, conduit connections, and positioning for optimal airflow and serviceability.

Completed comprehensive preventive maintenance inspection on two-year-old air conditioning system. Performed visual inspection of evaporator coil assembly, refrigerant lines, control boards, and electrical connections. All components found operating within normal parameters with no deficiencies noted.

Responded to no cooling complaint on system less than 10 years old with additional reports of water leaking from furnace and blank thermostat display. Upon arrival, found thermostat had lost power and was non-functional, preventing system operation. Diagnosed thermostat issue as unrelated to previously reported intermittent noise concerns, and determined water leak from furnace was a separate issue requiring independent evaluation. Brought diagnostic equipment to site for system assessment and troubleshooting of cooling failure and electrical concerns affecting thermostat operation.

Provided comprehensive assessment and free estimate for complete residential rewire project. Evaluated existing electrical infrastructure throughout the property, including bathroom circuits with modern fixtures and bedroom areas showing wall damage indicative of outdated wiring systems. Documented current conditions with detailed photography of accessible areas, noting switch configurations, outlet placements, and overall electrical distribution requirements. Utilized diagnostic testing equipment to assess circuit integrity and identify potential code violations requiring correction during full rewire implementation.

Responded to no cooling complaint on 6-year-old residential AC system with recurring issues. Upon inspection, found outdoor condenser unit with heavily soiled coils showing significant dirt accumulation, water staining, and mineral deposits restricting airflow. Cleaned condenser coils, removed debris from base of unit, and restored proper system operation.

Responded to service call for natural gas water heater approximately four years old not producing adequately warm water. Upon arrival, performed diagnostic testing and temperature measurements to assess system performance. Inspected water heater components and verified proper operation of heating elements and thermostat controls to identify cause of insufficient water temperature.

Replaced defective electrical disconnect box for HVAC system. Removed old gray metal enclosure and installed new disconnect with proper fused switch mechanism. Reconnected all electrical wiring including power conductors and ground wire to appropriate terminals, verified secure connections, and confirmed proper operation of disconnect switch.

Responded to warranty callback regarding water heater installation from 2023 that was flagged during home inspection as not meeting code requirements. Upon arrival, performed comprehensive inspection of the unit and all associated components including copper piping connections, expansion tank, venting system, and mounting configuration. Documented current installation conditions with detailed photography showing water heater positioned against painted masonry wall with copper supply lines, brass fittings, expansion tank, and galvanized metal ductwork connections. Verified all plumbing connections, reviewed clearances, checked TPR valve discharge piping, examined venting configuration, and assessed compliance with current plumbing code standards. Installation found to meet applicable code requirements at time of original installation.

Completed MVP cooling maintenance visit on residential HVAC system. Inspected and photographed dual capacitor with proper wire connections, verified secure mounting bracket, and noted minor moisture accumulation on unit housing consistent with normal condensation. Performed airflow measurement at supply register using digital meter to confirm proper system performance and adequate cooling delivery throughout occupied space.

Completed scheduled BS-MVP cooling maintenance on two HVAC units. Inspection revealed significant rust and corrosion on exterior surfaces and refrigerant lines of one unit, indicating prolonged moisture exposure. Documented condition of ductwork showing corrugated metal interior with insulated piping runs. Performed standard maintenance procedures including system inspection, component evaluation, and photographic documentation of equipment condition for service records. Unit operational at time of departure, though corrosion issues noted for future monitoring and potential component replacement recommendations.

Completed routine MVP cooling maintenance visit on one-year-old residential air conditioning system. Performed comprehensive inspection of outdoor condenser unit, which showed normal operating condition with no visible damage, rust, or unusual wear patterns. Unit is properly installed on black plastic pad with adequate clearance from building exterior and surrounding landscaping, with electrical conduit and refrigerant lines secured appropriately.

Completed MVP air conditioning maintenance service on residential HVAC system. Performed comprehensive inspection of air handler unit, verified proper operation of control board and electrical components, checked condensate drain lines and PVC piping for proper flow and connections, and confirmed all safety switches and disconnects functioning correctly. System tested and operating within normal parameters upon completion.

Completed routine maintenance visit on a 4-year-old residential air conditioning system as part of the MVP recurring service program. Performed comprehensive inspection of both indoor furnace/air handler unit and outdoor heat pump condenser, verified proper operation of all components, checked refrigerant levels at service ports, and documented equipment condition with photographic records showing system in good working order with normal weathering for age.

Completed MVP Cooling Visit maintenance service on residential air conditioning system. Performed electrical diagnostics and measurements using digital clamp meter to verify proper amperage draw and system performance. All tested parameters within normal operating specifications, unit operating efficiently.

Completed routine MVP cooling maintenance on a 2-year-old Lennox residential HVAC system. Performed comprehensive inspection of outdoor condenser unit and indoor furnace components, verified proper operation of all equipment, and documented system condition through photographic records. All components found to be in good working order with no deficiencies noted.

Completed routine HVAC maintenance on outdoor cooling unit, which included inspection of condenser coil showing significant dirt accumulation and streaking patterns requiring attention. Inspected and evaluated electrical components including dual element time delay fuses rated at 200 amps, disconnect assembly, and associated wiring connections to ensure proper system operation and safety compliance.

Conducted comprehensive assessment of existing HVAC system in basement mechanical room for equipment replacement estimate. Documented current furnace, air handler, and ductwork configuration including metal supply plenum connections and distribution layout. Photographed equipment specifications, clearances, and existing infrastructure to provide accurate replacement proposal for aging heating and cooling system.

Completed comprehensive AC maintenance inspection on residential cooling system. Performed electrical panel inspection, verifying all wire connections, contactor operation, and capacitor condition. All electrical components tested within normal operating parameters. System found to be in good working order with no immediate service needs identified.

Completed MVP cooling maintenance visit on residential HVAC system. Inspected outdoor condenser unit and noted heavy accumulation of dirt, dust, and debris on side mesh filter panels restricting airflow to condenser coils. Verified indoor furnace system operation and checked condensate drainage piping configuration with proper valve installation.