HVAC, Plumbing & Electrical in Cuyahoga Falls, OH

Performed routine cooling maintenance on Lennox outdoor condenser unit for MVP customer. System was inspected and serviced according to manufacturer specifications. Photographic documentation of the equipment was taken for service records.

Responded to service call for generator with activated yellow indicator light. Upon inspection, found unit in good physical condition with proper installation on concrete pad. Accessed interior control panel, checked BLDC display readings, verified electrical connections, and reset system which cleared the warning light. Generator now functioning normally with no operational issues detected.

Performed routine gas furnace maintenance including inspection of heat exchanger, blower motor assembly, and control board functionality. Examined copper tubing connections and verified proper wiring configuration of the blower motor. All components found to be in normal operational condition with no issues detected.

Performed scheduled maintenance on 3-year-old cooling system. Inspected outdoor condenser unit mounted on composite deck and examined electrical components including capacitor and wiring connections. System functioning normally with no issues identified during this preventative maintenance visit.

Performed scheduled maintenance on Kenmore outdoor air conditioning condenser unit. Observed significant dirt accumulation, debris, and corrosion on exterior components including protective grilles and housing. Documented condition with photos for service record.

Successfully replaced aging water heater with new Richmond model and installed new main water valve after coordinating with city for water shut-off at street. Completed all necessary connections to existing plumbing system and verified proper operation of the new equipment after installation.

Performed scheduled maintenance service on tanked water heater system. Completed flush and fill procedure to remove sediment buildup and mineral deposits. Inspected associated components including expansion tank and ventilation system, confirming proper operation and connections.

Installed dedicated circuit for hot tub, routing power from outdoor pool panel using 1-inch metallic sealtite conduit. Ran wiring through basement cavity near AC line set to reach hot tub location, maintaining required 5-6 foot clearance between spa disconnect and internal spa components. Connected whip from disconnect to control panel, completing installation per electrical code requirements.

Performed comprehensive maintenance tune-up on Lennox furnace located in utility closet. Inspected all components including heat exchanger, burners, and electrical connections. System is operating within normal parameters with proper airflow through ductwork and no signs of damage or anomalies detected.

Performed standard maintenance on Goodman furnace system. Inspected flame sensor and cleaned component to ensure proper operation. Visual inspection of all ductwork connections, gas lines, and electrical wiring confirmed system is functioning correctly with no visible issues.

Performed scheduled water heater flush service on Ruud Professional tanked water heater. Connected drainage hose to bottom valve and thoroughly flushed system to remove sediment buildup. Inspected unit, connections, and expansion tank for proper operation after service completion.

Cleared a severely clogged wash basin drain line on the second floor requiring replacement of approximately 9.5 feet of drain pipe. Installed new drainage components including proper P-trap configuration and ensured connection to the main cast iron waste stack. System now functioning properly with no leaks observed during testing.

Completed installation of a new 80K BTU air conditioning system with proper connection of refrigerant lines and electrical components. Installed new shutoff valve on condensate drain line and verified proper drainage. System startup performed with all functions operating within manufacturer specifications.

Completed installation of a new complete HVAC system, including a Trane furnace with connected ductwork in the basement utility area and a Lennox outdoor AC condenser unit (80 AC 600 model). System was properly mounted with all necessary connections, including refrigerant lines running to the house, and the outdoor unit was positioned on a mounting pad adjacent to the home's exterior.

Responded to emergency water leak in basement of 65-year-old home. Located and operated main water shut-off valve which had significant corrosion and oxidation on copper pipes and valves. Addressed water accumulation and educated homeowner on location of main water valve for future reference.

Responded to service call for kitchen sink/disposal drain clog caused by food waste. Inspected the P-trap assembly and garbage disposal unit, which customer had already attempted to clear by emptying pipes. Successfully cleared obstruction in the drain line beyond the accessible P-trap using professional-grade equipment, restoring proper drainage to both kitchen sink basins and disposal unit.

Performed annual maintenance on a 1-year-old heating system. Inspected internal components including gas valve assembly, wiring connections, and control board. All components functioning properly with no issues detected; system is operating within manufacturer specifications.

Performed scheduled maintenance on Burnham boiler system. Inspected pressure gauge readings and verified proper operation of all components. System is functioning correctly with no issues identified.

Conducted site evaluation for new generator installation, inspecting exterior location adjacent to foundation access panel and surrounding landscaped area. Examined basement/utility space to assess electrical connection points, available clearance for equipment, and potential routing for power lines and ventilation. Photos documented both proposed exterior mounting location and interior connection points for engineering review.

Responded to service call for clogged bathtub drain. Inspection revealed significant mineral deposits and rust staining around bathroom sink drain and basin. Performed drain clearing service on the affected plumbing system, which included accessing and clearing the black ABS drain pipe with elbow joint connected to PVC piping beneath the structure.