Trusted HVAC, Plumbing & Electrical Services in Medina, OH

Responded to service call for 15-year-old central air conditioning system running continuously without adequate cooling. Diagnosed low refrigerant levels and identified evidence of refrigerant leak on suction line based on oily residue and lack of proper temperature differential. Initial refrigerant supply depleted during service; second appointment scheduled to complete refrigerant recharge and verify system operation.

Installed dedicated electrical circuit for tankless water heater installation. Ran new wiring through unfinished ceiling space, routing cable through floor joists and coordinating placement around existing plumbing, HVAC ductwork, and structural members. Secured all conductors per code requirements and completed rough-in wiring in preparation for final connections.

Performed scheduled tankless water heater descaling and flush service as requested. Completed maintenance procedure to remove mineral buildup and ensure optimal unit performance and efficiency.

Performed scheduled maintenance on two outdoor Generac standby generators, both approximately four years old. Completed routine inspections including visual assessment of engine components, connections, and housing integrity on both units. This visit represents the second appointment; return service scheduled to complete circuit rearrangement on generator transfer switch to optimize load distribution and system performance.

Completed electrical estimate for generator installation at residential property. Documented existing electrical panel configuration, including main breaker and circuit distribution for future generator integration planning. Photographed current electrical infrastructure to assess capacity and determine optimal connection point for standby generator system.

Responded to service call for leaky bathtub faucet in residential bathroom. Upon inspection, identified faulty cartridge in single-handle shower control valve as source of leak. Removed existing cartridge using appropriate extraction tools and replaced with new Moen 1222-B cartridge. Tested fixture operation to confirm proper function and verified leak was resolved.

Completed warranty service call on HVAC system. Verified refrigerant charge using digital scale, measured 13.6 ounces, and documented equipment condition with photos for warranty records.

Completed MVP air conditioning maintenance service on residential Lennox cooling system. Inspected outdoor condenser unit and found normal operating conditions with minor debris accumulation from seasonal leaf fall. Discovered heavily soiled and deformed air filter exhibiting significant sagging and particulate buildup, indicating restricted airflow and reduced system efficiency. Replaced failed filter to restore proper air circulation and system performance.

Completed comprehensive MVP air conditioning maintenance on outdoor condensing unit. Performed system diagnostics including electrical measurements, recording operating voltage and amperage readings of 400V and 32.54A respectively using calibrated clamp meter to verify proper compressor and fan motor performance. Inspected exterior coil condition, noting significant accumulation of dirt, dust, and debris within fin spacing and water staining patterns on unit panels indicating need for thorough cleaning during future service intervals. All electrical parameters within manufacturer specifications. System operating properly at time of service completion. Customer approved service renewal for continued maintenance coverage with technician.

# HVAC System Replacement and Ductwork Installation ## Work Performed Completed full HVAC system replacement in attic space, removing existing equipment and installing new air handler unit with proper configuration. Replaced all attic ductwork to establish correct airflow distribution throughout the system. The existing air handler was disconnected and removed from service. A new Sonnet brand air handler unit was positioned and secured vertically in the attic space between structural joists. The unit was installed with proper clearances for serviceability and airflow requirements. All old ductwork was removed from the attic. New flexible ductwork was installed and connected to the air handler, routed through the attic framing with appropriate support and secured with metal clamps and mounting brackets. Metallic flexible conduit was installed for electrical connections, attached to white metal panels using proper mounting hardware. Reflective insulated ductwork was installed throu

Completed installation of surge protection device on HVAC system. Accessed furnace control panel and outdoor condensing unit to integrate surge protector with existing electrical components and control boards. Verified proper wiring connections, tested system operation, and confirmed all components functioning correctly with surge protection now in place.

Responded to service call for excessive basement moisture following recent AC installation. Inspected Lennox air conditioning system and indoor furnace unit for potential water leaks or condensate drainage issues. Examined condensate drain lines, PVC piping connections, and drainage system routing to identify source of moisture accumulation. Verified proper condensate pump operation and checked for any blockages in drain lines. Inspected evaporator coil drain pan for cracks or overflow conditions. Assessed outdoor condenser unit placement and surrounding area for proper drainage away from foundation. No active water leaks observed on floor during inspection, but confirmed significant dehumidifier usage indicating elevated humidity levels. Evaluated condensate management system integrity and provided recommendations to address moisture concerns related to HVAC operation.

Completed MVP recurring cooling maintenance visit on residential HVAC system. Performed comprehensive inspection of indoor air handler unit located in utility closet, including Lennox filtration system, ductwork connections, and refrigerant lines. Exterior condenser unit showed significant accumulation of dirt, dust, and debris on coil fins and casing, which was addressed during service to restore proper airflow and system efficiency. All components inspected and system operational upon completion.

Responded to UV light service indicator alert on thermostat for recently installed Air Scrubber system. Inspected both Air Scrubber units installed in June 2025, verified proper operation of UV-C lamps, and reset service indicator. Confirmed humidifier and overall HVAC system functioning properly with 9-year-old air conditioning unit showing normal operating conditions.

Completed scheduled MVP cooling maintenance visit at requested early morning time slot. Performed comprehensive system inspection including examination of evaporator coil assembly and ductwork components. Documented current condition of finned coils showing moderate dust accumulation between fins and inspected refrigerant lines and insulation integrity throughout accessible areas of the system. Verified proper installation of duct insulation and assessed overall HVAC unit housing condition. System operational at time of service completion.

Replaced leaking washing machine supply lines in basement utility area. Repaired water supply line leading to toilet and completed new toilet installation using fixture provided by property owner. Removed existing reverse osmosis system and replaced utility tub with owner-supplied unit, reconnecting all necessary plumbing connections and ensuring proper drainage and water supply functionality.

Completed comprehensive MVP gas furnace maintenance including thorough inspection of evaporator coil assembly and electrical control components. Cleaned and inspected evaporator fins, verified proper electrical connections at contactor relay, and confirmed all wiring configurations and control systems are functioning correctly for optimal heating season performance.

Responded to water leak in basement originating from upstairs toilet. Upon inspection, identified active leak causing water damage to subfloor and OSB sheathing where plumbing penetrates through floor assembly. Water infiltration resulted in significant staining and deterioration of structural panel material around PVC drain lines. Documented damage with photographs showing affected area and plumbing configuration. Confirmed leak source and scheduled follow-up appointment for repair work.

Responded to no airflow complaint on 9-year-old air conditioning system. Found heavily soiled filter completely restricting airflow through the unit, replaced filter, restored normal system operation, and verified humidifier functionality per customer request.

Completed installation of new air conditioning system with evaporator coil in residential basement mechanical room. Installed new A-frame evaporator coil on existing Lennox furnace, connected refrigerant lines, and integrated with new sheet metal ductwork system featuring vertical supply plenum with proper transitions. Verified all connections, tested system operation, and ensured proper airflow throughout the distribution system.