Air Conditioning, Heating, Electrical & Plumbing Services in Uniontown, OH

Completed MVP annual air conditioning maintenance on residential outdoor condensing unit approximately two years old. Performed comprehensive system inspection including visual examination of cabinet panels, protective screening, and refrigerant line connections. Verified proper unit placement on isolation pad and confirmed electrical disconnect box accessibility. Checked condensate drainage system and placed overflow pan for monitoring. All components found to be in serviceable condition with screening material intact and unit operating within normal parameters. Discussed service agreement renewal options and clarified warranty coverage details with homeowner.

Completed preventive maintenance on 7-year-old residential air conditioning system. Inspected electrical disconnect panel, verifying all connections, contactor operation, and capacitor condition. Cleaned condenser coil fins and confirmed proper airflow through heat exchanger. All components operating within normal parameters upon completion of service.

Completed scheduled cooling maintenance visit from 2023. Performed system diagnostics and temperature measurements, recording supply air temperature at 51.5°F. Inspected outdoor condensing unit, verified electrical connections, capacitor condition, and overall system operation to ensure proper cooling performance.

Completed annual maintenance tune-up on one-year-old air conditioning system. Inspected electrical components including contactor, capacitor, and control wiring; verified proper connections and secure wire routing. Evaluated blower wheel assembly for cleanliness and operational condition, noting minor dust accumulation typical of normal operation.

Completed BS-MVP cooling maintenance visit on 5-year-old Lennox system. Performed comprehensive inspection of outdoor condenser unit and indoor furnace with connected ductwork. Unit operating within normal parameters. All components inspected, cleaned, and tested per maintenance protocol.

# Geothermal Unit Non-Operational - Moisture Issue Resolved Responded to service call for non-operational 11-year-old geothermal heat pump system. Upon arrival, performed comprehensive system diagnostic and visual inspection of air handler and evaporator coil assembly. Inspection revealed excessive condensation and moisture accumulation throughout the air handler cabinet and on surrounding surfaces. Heavy water droplets observed on cabinet walls with visible streaking and pooling on the drip pan and mounting platform. The evaporator coil showed signs of prolonged moisture exposure with debris accumulation on the base platform. Multiple surfaces exhibited water damage consistent with drainage system failure or inadequate condensate removal. Examined the corrugated flexible ductwork connection and cabinet sealing at the unit junction. Identified compromised condensate drainage as primary cause of system shutdown. The moisture accumulation indicated either a clogged condensate line, fa

Installed two bathroom ventilation fans in residential property to improve air circulation and moisture control. Ran electrical wiring through basement ceiling joists to power units, secured conduit and connections per code requirements, and verified proper operation of both exhaust fans upon completion.

Replaced evaporator coil on residential HVAC system. Parts were ordered and received at shop prior to service appointment. Completed installation and verified system operation using digital temperature measurements to confirm proper cooling performance.

Conducted comprehensive site assessment for furnace and air conditioning system replacement. Evaluated existing Bryant furnace installation in basement mechanical room, documenting current ductwork configuration, plenum connections, and overall HVAC infrastructure condition. Inspected exterior condensing unit location and surrounding utility area, noting drainage conditions and clearance requirements for new equipment installation.

Responded to return service call for recurring thermostat and furnace communication failure on 10-year-old Lennox system. Upon inspection, discovered severely damaged low-voltage control wiring with burned and melted insulation, exposed copper conductors, and heat damage at wire junction point. Thermostat displayed Alert Code 105 indicating wiring issue and service urgent notification. Documented extensive wire damage affecting multiple colored control wires (red, green, blue, yellow, white, tan) at central connection point, which was causing communication breakdown between thermostat and HVAC equipment. Recommended immediate wiring repair or replacement to restore proper system communication and prevent potential safety hazard from damaged electrical connections.

Completed routine cooling maintenance visit on 7-year-old Lennox air conditioning system. Performed comprehensive inspection of indoor furnace unit and outdoor condenser, verified proper operation of all components, checked refrigerant levels, inspected electrical connections and controls, cleaned condenser coils, confirmed adequate airflow through system, and noted Aprilaire filter present for replacement. System operating within normal parameters with no immediate service needs identified.

Completed routine maintenance tune-up on a 6-year-old outdoor condensing unit. Inspected condenser coils which showed moderate accumulation of dirt and debris on exterior fins, documented unit condition, and verified clean air filter at indoor air handler with proper pleating and structural integrity intact.

Completed preventive maintenance on 11-year-old residential air conditioning system. Performed comprehensive inspection of outdoor condensing unit, including electrical connections, capacitor, contactor, and internal components. Verified system pressures and temperatures using digital manifold gauges, confirming proper refrigerant charge and operational parameters within manufacturer specifications.

Completed BS-MVP cooling maintenance visit on a 2-year-old residential air conditioning system located in the backyard. Performed comprehensive system inspection, took temperature and pressure readings showing -49.1°F measurement at the evaporator coil, and documented unit condition with the condenser showing normal outdoor debris accumulation on the cabinet panels. All components operating within manufacturer specifications at time of service.

Completed preventive maintenance inspection on 5-year-old Lennox air conditioning system for MVP customer. Performed comprehensive evaluation of indoor furnace unit and outdoor condenser, verified proper operation of all components, checked refrigerant line connections, and documented equipment condition with photos. System found operating within normal parameters with no immediate service needs identified.

Completed scheduled maintenance visit on 10-year-old air conditioning system. Upon inspection, discovered significant frost and ice accumulation on evaporator coil copper piping, indicating restricted airflow or low refrigerant charge. Inspected blower assembly and found dust buildup on squirrel cage fan blades affecting system performance. Cleaned blower wheel components and verified motor operation. Addressed airflow restriction issues contributing to coil icing condition. System operational upon completion of maintenance procedures.

Completed comprehensive tune-up on Mitsubishi Electric split-system heat pump (Model MUZ-GL12NA) located at rear of property. Performed internal inspection of wall-mounted unit, verified operational temperature readings at 55.5°F, and confirmed all system components, labels, and safety warnings are intact and functioning properly.

Performed scheduled maintenance tune-up on a two-year-old Lennox EL16XC1 air conditioning system. Completed comprehensive inspection of outdoor condenser unit and indoor furnace components, verified electrical connections and voltage specifications, checked refrigerant levels and pressures, inspected ductwork and ventilation systems, and confirmed all safety labels and warnings were intact. Unit operating within normal parameters with no issues identified.

Completed routine maintenance on a one-year-old Bryant cooling system. Performed comprehensive inspection of furnace unit, refrigerant lines, condensate drain pan, and associated copper piping. All components operating within normal parameters with no deficiencies noted at time of service.

Performed camera inspection of 4-inch corrugated downspout drainage line to locate blockage. Successfully identified obstruction point and assessed condition of underground drainage system from foundation to ditch connection. Provided detailed estimate for replacement of damaged section of downspout line based on camera findings and site evaluation.