Air Conditioning, Heating, Electrical & Plumbing Services in Uniontown, OH

Completed comprehensive air conditioning tune-up service including visual inspection of evaporator coil assembly and heat exchanger components. System components showed normal operational wear with some dust accumulation; all major elements including refrigerant lines, coil fins, and electrical connections were assessed and found to be functioning within acceptable parameters.

Completed MVP recurring cooling maintenance visit on residential HVAC system. Performed comprehensive system diagnostics including temperature differential measurements at supply register, recording 65°F air temperature at floor-level vent. Conducted electrical testing on outdoor condensing unit using digital multimeter, measuring 15.4 volts at system components to verify proper electrical operation. Inspected return air ventilation showing moderate dust accumulation on grille, typical for residential system requiring routine filter maintenance. All critical system parameters checked and operating within normal specifications for continued cooling performance.

Completed scheduled MVP cooling maintenance visit on 10-year-old system. Performed comprehensive inspection of control board assembly, verifying proper operation of all electronic components, relays, and wiring connections. Inspected blower wheel and housing, noting minor dust accumulation on base pan. All electrical connections secure, circuit boards functioning within normal parameters, and blower assembly operating properly. System tested and confirmed operational.

Completed scheduled cooling maintenance on residential outdoor HVAC unit. Performed comprehensive system inspection including examination of condenser coil, electrical components, control board, wiring connections, and blower motor assembly. All components found to be in proper working order with normal operational wear, system tested and confirmed operating within manufacturer specifications.

Completed MVP recurring cooling maintenance visit on 5-year-old residential HVAC system. Performed comprehensive inspection of indoor Lennox furnace unit and outdoor condenser unit, verified all refrigerant lines and connections, checked condensate drainage system, and confirmed proper operation of all components. Noted outdoor condenser coils showing differential weathering with heavier buildup on one panel; system operating within normal parameters with adequate airflow and no immediate service concerns identified.

Completed estimate for replacement of customer-supplied furnace and air conditioning system. Assessed existing HVAC equipment location in basement utility area, including current furnace, ductwork configuration, and humidifier setup. Evaluated installation requirements for new equipment, noting existing sheet metal plenum connections, cylindrical ductwork with elbow configuration, and copper refrigerant line routing. Documented current system layout and mechanical room conditions to provide accurate installation proposal for self-supplied equipment to be purchased through Famous Supply.

Completed preventative maintenance inspection on 7-year-old rooftop air conditioning unit. Accessed unit using tall ladder, removed access panel, and performed comprehensive system evaluation. Inspected capacitor, electrical connections, and wiring harness - all components found to be in functional condition with connections intact. Documented system condition with photos for maintenance records.

Completed MVP Cooling Visit maintenance on a 3-year-old HVAC system. Inspected evaporator coil assembly and verified electrical readings at 236.59 volts using digital multimeter. Initial appointment rescheduled due to high demand, with follow-up maintenance visit scheduled for completion.

Responded to service call for assessment of underground drainage system potentially affecting downspout discharge lines. Upon arrival, conducted visual inspection of exterior drainage infrastructure and located accessible cleanout point in ground surrounded by overgrown vegetation and ground cover. Documented existing conditions with photographs showing drainage access point obscured by mixed vegetation, dried grass material, and exposed soil. Provided professional second opinion evaluation of underground drain line system and discussed findings with property owner regarding potential blockage concerns affecting proper water drainage from roof downspout connections.

Completed MVP cooling maintenance visit on 6-year-old system located outside basement door. Upon inspection, discovered damaged wiring at contactor with exposed and frayed copper conductors on red power wire, presenting potential safety hazard and operational risk. Documented equipment condition with photos showing outdoor condenser unit on concrete pad and electrical connection assembly with compromised wiring requiring future repair or replacement to ensure safe system operation.

Responded to no-cooling complaint on 9-year-old Lennox central air conditioning system. Upon arrival, confirmed indoor blower, outdoor fan, and compressor were all operating, but both refrigerant lines remained at ambient temperature after extended run time with no heat rejection at condenser and no cooling delivered indoors. Diagnosed complete loss of refrigerant charge due to leak in evaporator coil. Located active leak at coil connection point. Recovered remaining trace refrigerant from system, replaced failed evaporator coil assembly, pressure tested system to 350 PSI and held for one hour with no pressure drop, evacuated system to 500 microns, and recharged with manufacturer-specified refrigerant to proper subcooling and superheat levels. Replaced deteriorated line insulation on suction line. Verified proper system operation with appropriate temperature split across evaporator coil and warm discharge air at condenser. System restored to full cooling capacity.

Conducted comprehensive evaluation of existing furnace and air conditioning system for equipment replacement estimate. Customer was previously advised by another HVAC company that full system replacement was necessary. Performed thorough inspection of outdoor condensing unit and indoor infrastructure, documented existing equipment condition and installation configuration. Assessed crawl space accessibility, existing ductwork, refrigerant line routing, and electrical connections to determine scope of replacement work required. Provided detailed replacement recommendations and system specifications based on current installation parameters.

Completed MVP preventive maintenance cooling visit on 4-year-old residential air conditioning system. Performed comprehensive inspection of outdoor condensing unit, including evaluation of electrical disconnect panel and internal components. Inspected electrical connections, wiring, and terminal blocks within disconnect box. Removed and examined condenser coil panels, revealing significant accumulation of organic debris, decomposed leaves, and dirt on concrete mounting pad and around compressor base. Assessed copper refrigerant line connections and compressor unit condition. Documented system condition through photographic inspection showing moderate debris buildup requiring attention during routine maintenance cycle.

Responded to service call for backflow prevention system malfunction. Upon inspection, evaluated the Wilkins Zurn backflow preventer assembly rated at 375 PSI, including ball valves, Y-strainer configuration, and associated piping mounted at exterior foundation level. Documented current system condition with photographs and provided estimate for necessary repairs to restore proper backflow prevention functionality.

Installed a 40-gallon Bradford White water heater in basement utility area with all required code upgrades and water heater installation kit. Completed proper connections to existing copper supply lines, installed expansion tank, and ensured all plumbing work met current building code specifications.

Completed MVP recurring cooling maintenance visit on residential split system. Performed standard inspection of indoor furnace unit and outdoor Lennox condenser. Verified proper operation of both components, checked refrigerant levels, and confirmed all electrical connections secure. System operating within normal parameters at time of service.

Completed preventive maintenance inspection on outdoor AC unit for MVP customer. Removed access panel and inspected electrical components including capacitor, wiring connections, and blower motor assembly. Verified proper operation of blower wheel and documented system condition with photos showing clean interior components and properly functioning equipment.

Completed scheduled MVP cooling maintenance visit on Goodman split system unit, model GEX1302430. Performed comprehensive inspection of outdoor condensing unit, including electrical components, capacitor, contactor, and wiring connections. All system components found operating within manufacturer specifications with no immediate service needs identified. Unit documentation photographed for service records.

Performed free estimate on 30-year-old American Water Heaters brand tanked water heater experiencing inadequate heating performance. Upon inspection, confirmed unit age and deteriorated heating capacity, documented existing installation including piping connections and current condition of equipment in utility room setting.

Responded to service call for garbage disposal evaluation in 33-year-old residence. Upon inspection, found existing disposal unit properly installed and connected beneath kitchen sink with standard mounting assembly, functional drain connections via corrugated hose to PVC drainage system, and secure electrical wiring. Assessed unit condition and verified all components including mounting flange, discharge plumbing, and electrical connections were intact and operational. Determined existing garbage disposal did not require replacement at this time.