Air Conditioning, Heating, Electrical & Plumbing Services in Uniontown, OH

# MOBILE HOME AC 1ST JOB Completed installation of new air conditioning system with evaporator coil for mobile home application. Installed outdoor condensing unit and indoor evaporator coil assembly. Ran refrigerant line set between outdoor and indoor components. Evacuated system to remove moisture and non-condensables from refrigerant lines. Charged system with appropriate refrigerant type and quantity per manufacturer specifications. Performed system startup and commissioning procedures. Used Testo 550 digital manifold gauge to verify proper refrigerant pressures and temperatures throughout system operation. Monitored suction and discharge pressures to confirm system was operating within normal parameters. Checked superheat and subcooling values to ensure proper refrigerant charge. System operating efficiently with appropriate temperature splits and pressures. All electrical connections verified and secured. Unit tested and left in proper working condition.

Completed electrical service for above-ground pool installation, including running electrical lines from main panel to pool equipment location. Assessed existing electrical panel capacity and circuit availability to support new pool equipment load requirements, with panel showing adequate breaker space for dedicated pool circuit installation.

Responded to service call for outdoor spigot that would not shut off properly. Upon inspection, traced the issue to the shutoff valve located in the basement utility area. Replaced faulty valve assembly on the copper supply line serving the exterior spigot. Tested operation from both interior shutoff and exterior handle to confirm proper water flow control and complete shutoff with no leaks. System restored to full functionality.

Installed new gas line extension from existing residential gas meter to above-ground pool heating system. Ran black iron pipe from meter location on exterior wall, routing approximately 30-40 feet across property to pool equipment pad where SwimPro pool heater unit was positioned. Connected gas supply line to heater inlet with appropriate fittings and unions for future serviceability. All connections were properly threaded, sealed with approved pipe compound, and pressure tested to ensure system integrity and compliance with local gas code requirements.

Replaced transformer with timer on back deck for exterior lighting control. Swapped out two Siemens breakers in the main electrical panel with Square D breakers for compatibility and proper circuit protection. Installed new 240-volt and 120-volt 20-amp circuits in the garage using shared conduit, terminating in two separate junction boxes equipped with GFCI breakers for enhanced safety. Replaced malfunctioning light switch controlling back deck lighting. All installations tested and verified operational upon completion.

Completed MVP cooling maintenance visit on 5-year-old system. Inspected electrical control panel and capacitor, noting corrosion present on capacitor terminal connections. Measured supply air temperature at 49.5°F, confirming adequate cooling performance. All electrical connections secure and system operating within normal parameters at time of service.

Completed BS-MVP cooling maintenance visit on 3-year-old air conditioning system. Performed comprehensive system inspection including blower wheel examination and supply air temperature verification, which measured 52.0°F indicating proper cooling operation. All components found operating within normal parameters with standard dust accumulation noted on blower assembly consistent with regular use.

Completed scheduled maintenance visit for MVP customer's outdoor air conditioning condenser unit. Performed visual inspection of split-system condenser positioned on elevated deck, confirmed unit operational status, and documented equipment condition through photographic records. Top-mounted air filter showed dirt accumulation and discoloration, indicating normal usage patterns since last service interval.

Completed a comprehensive 200-amp electrical service upgrade with full compliance to 2023 National Electrical Code requirements. Installed new exterior disconnect switch, upgraded main service panel, and integrated whole-home surge protection system. All necessary code updates were implemented, including proper grounding, bonding, and weatherhead installation with exterior-grade conduit and meter assembly mounted on residential siding.

Completed MVP preventative maintenance cooling visit on 10-year-old Lennox system. Inspected indoor air handler unit, which showed good overall condition with clean cabinetry, properly insulated refrigerant lines, and functional condensate drainage. Outdoor condensing unit exhibited heavy dirt and debris accumulation on exterior surfaces and condenser coils, requiring thorough cleaning to restore proper airflow and heat transfer efficiency. Cleaned condenser coils, cleared debris from unit base, and verified proper refrigerant line connections and electrical conduit routing. System operational upon completion.

Performed routine air conditioning tune-up and preventative maintenance on residential cooling system. Conducted comprehensive system diagnostics including electrical measurements using clamp meter to verify proper amperage draw and voltage levels at outdoor condensing unit. All readings were within manufacturer specifications, and no issues or deficiencies were identified during inspection.

Completed preventive maintenance cooling visit on HVAC system. Performed electrical diagnostics using clamp meter, recording 20.0A current draw and 237.2V supply voltage at contactor. Inspected and replaced dual fuse assembly containing GE and Littelfuse FLNR 25A Class RK5 fuses to ensure proper overcurrent protection for system operation.

# HVAC Service Completed Responded to service call for 6-year-old Lennox air conditioning unit experiencing inadequate cooling performance and intermittent Nest thermostat shutdowns occurring daily at consistent intervals for 20-minute durations. Upon arrival, performed visual inspection of outdoor condensing unit. Found extensive accumulation of dirt, dust, and environmental debris coating exterior panels and restricting airflow through condenser coil louvers. Unit positioned on concrete pad with adequate clearance, though surrounding mulch and vegetation contributed to debris buildup. Diagnosed primary issue as severely restricted condenser coil airflow due to heavy contamination. The reduced heat transfer capacity caused system to run extended cycles without achieving target temperature, resulting in increased runtime and elevated operating pressures. Thermostat safety shutdowns were attributed to system overheating from inadequate condenser performance. Performed comprehensive

Provided comprehensive estimate for complete HVAC system replacement including gas furnace and air conditioning unit with partial zoning configuration. Assessed existing outdoor condensing unit and interior ductwork system, documenting current equipment condition and infrastructure to develop replacement specifications. Consulted with homeowner regarding system options and zoning requirements for optimized comfort control throughout the residence.

Responded to no cooling call on 7-year-old air conditioning unit that was not operating. Upon inspection, accessed electrical compartment and identified failed capacitor as root cause of system failure. Replaced defective capacitor with proper OEM replacement, verified all electrical connections, tested system operation, and confirmed unit returned to normal cooling function.

Completed comprehensive cooling maintenance on outdoor air conditioning condenser unit. Performed diagnostic testing using electronic meter with multi-lead connections to assess system performance, refrigerant levels, and electrical parameters. Unit inspected and serviced per manufacturer specifications to ensure optimal operation for the cooling season.

Responded to no cooling complaint on residential air conditioning system. Upon arrival, diagnosed outdoor condenser unit and found system not operating. Restored cooling operation to unit and verified proper system function before departure.

Responded to service call for lack of airflow to upstairs bedrooms on zoned cooling system. Upon inspection, found system operating without damper switch controls, preventing proper zone temperature regulation. Documented equipment specifications and observed heavily soiled air filter with significant dust and debris accumulation restricting airflow throughout pleated media. Customer unavailable after 3:00 PM to discuss findings and recommended repairs.

Responded to no cooling complaint on approximately 10-year-old residential air conditioning system. Upon arrival, found outdoor condenser unit heavily soiled with accumulated dirt and debris on exterior panels and coils, with vegetation growth around base potentially restricting airflow. Inspected indoor furnace and air handler equipment in basement, noting standard forced-air configuration with PVC condensate drainage system. Diagnosed cooling issue, performed necessary repairs to restore system operation, and recommended routine maintenance including coil cleaning and vegetation clearance to ensure optimal performance and efficiency.

Completed installation of new air conditioning condenser unit and evaporator coil system at residential property. Mounted outdoor condenser unit on rubber isolation pad against exterior wall with proper clearances, installed brass service valves with locking caps on refrigerant lines, and ran copper lineset with foam insulation between indoor and outdoor components. Connected PVC condensate drain line from evaporator coil through exterior wall, secured all refrigerant connections, and verified proper system operation upon startup.