Your Trusted HVAC, Plumbing & Electrical Experts in Wadsworth, OH

Replaced existing 1/2 horsepower kitchen garbage disposal unit with new disposal of equivalent or greater capacity per customer request. Completed same-day installation including proper mounting, drain line connections, and electrical hookup, ensuring all components were secured and tested for proper operation.

Completed BS-MVP cooling maintenance visit on 7-year-old Lennox system with outdoor condensing unit. Performed standard preventive maintenance inspection, verified system operation, and documented equipment condition with photos showing furnace installation with proper PVC venting and drainage configuration.

Responded to no cooling call on 6-year-old Lennox air conditioning system. Upon arrival, performed diagnostic evaluation of outdoor condenser unit and assessed system operation. Unit was accessible on concrete pad at exterior of residence with adequate clearance for service work. Completed standard troubleshooting procedures to identify cause of cooling failure and restored system to proper operation.

Completed MVP cooling maintenance visit on system over 13 years old. Upon inspection, discovered significant mold contamination at supply duct penetration point in ceiling, with heavy green and yellowish growth on interior surfaces surrounding duct connection. Documented conditions with photos for customer records. Inspected outdoor condensing unit and verified all electrical components including dual-run capacitor, contactor relay, and wiring connections are functioning properly with secure installations and proper organization.

Replaced deteriorated cast iron soil stack from basement floor through second story bathroom due to multiple pinhole rust leaks. Installed new PVC piping system from basement connection point (banded to existing cast iron where viable) up through second floor toilet with new PVC closet flange. Accessed and opened wall cavity behind refrigerator, ceiling above refrigerator area, and removed small cabinet to facilitate pipe replacement. Created access point in stairwell between floors for continuous pipe run. Adapted new PVC stack to existing 1 1/2" ABS branch lines serving upstairs shower and lavatory at closet 90 connection. All penetrations and access points prepared for finish work upon completion of two-day installation with helper assistance.

Completed annual HVAC tune-up and maintenance inspection. Performed system diagnostics using digital refrigerant gauges to verify proper operating pressures and temperatures. Removed and inspected air filter, which showed heavy contamination and debris accumulation requiring replacement to restore proper airflow and system efficiency.

Performed comprehensive air conditioning tune-up on 24-year-old unit. Inspected air handler cabinet, ductwork connections, and internal components; noted accumulated debris and minor discoloration in base pan consistent with unit age. All accessible components evaluated, system operational upon completion.

Conducted on-site electrical assessment for residential standby generator installation in limited-use backyard area near existing main electrical panel. Evaluated placement constraints due to restricted installation zone, confirmed proximity to breaker panel for efficient transfer switch connection, and documented existing conditions including concrete paver patio surface and available clearances from structure and HVAC equipment. Provided estimate for complete generator system installation with ongoing maintenance contract options.

Performed routine maintenance flush on a 3-year-old Navien tankless water heater to remove mineral buildup and maintain optimal performance. Connected descaling pump with flushing solution to the unit's service valves, circulated cleaning solution through the heat exchanger for the manufacturer-recommended duration, and thoroughly rinsed the system. Unit tested successfully after service with proper flow rates and temperature output restored.

Completed seasonal cooling maintenance and AC tune-up on a 5-year-old Lennox system installed in garage location. System was operational upon arrival and confirmed working properly throughout inspection. Performed comprehensive maintenance protocol including filter inspection, refrigerant level verification, electrical connection checks, condensate drain line assessment of PVC piping system, and air handler component evaluation. All components functioning within manufacturer specifications with no deficiencies noted.

Conducted on-site electrical assessment for generator installation at residential property. Evaluated existing 200-amp main service panel and electrical infrastructure to determine compatibility and requirements for backup generator system integration. Documented current panel configuration, available breaker spaces, and wire routing from main distribution panel to determine optimal connection point for automatic transfer switch. Assessed secondary electrical enclosure and associated wiring to verify adequate capacity for proposed generator load. Photographed electrical service equipment and panel layout for estimate preparation and future installation planning.

Completed annual preventative maintenance on residential air conditioning system for contract holder with five to six year old unit. Performed comprehensive inspection of evaporator coil assembly, verified refrigerant line connections and brass fittings for proper seal integrity, and examined electronic control board system including all PCB components, wire harnesses, and connector terminals. Inspected aluminum coil fins for damage, checked condensate drainage system including PVC piping, and verified all electrical connections and control circuits were secure and functioning properly. Unit operating within normal parameters upon completion of maintenance service.

Conducted comprehensive assessment of existing Trane furnace and air conditioning system for replacement estimate. Documented current equipment condition, including furnace unit with operational ventilation louvers, associated ductwork, gas line connections, and aged copper piping showing normal wear. Customer requested competitive pricing comparison for complete HVAC system replacement.

Completed routine HVAC maintenance visit for cooling system on residential Lennox outdoor condensing unit. Inspected exterior condenser unit, confirmed operational status with no visible damage or deterioration, and replaced heavily soiled air filter that had accumulated significant dust and debris buildup across pleated media, restoring proper airflow and system efficiency.

Completed routine maintenance inspection on two-year-old residential air conditioning system. Accessed indoor air handler unit, inspected all internal components including blower motor assembly, electrical connections, circuit boards, and condensate drainage system. Noted heavily soiled air filter with significant dust and debris accumulation throughout filter media. Examined all wiring harnesses, verified secure connections at control boards and motor terminals. Confirmed proper operation of blower assembly and verified condensate drain lines are clear and functioning correctly. All mechanical and electrical components operating within normal parameters. Unit performing as expected for age and usage.

Completed scheduled air conditioning maintenance visit for MVP customer. Performed comprehensive system inspection of outdoor condenser unit, verified proper electrical connections at contactor and capacitors, documented equipment condition with photos, and confirmed system operational status. Unit operating within normal parameters with no issues identified.

Completed comprehensive AC tune-up on a 3-year-old air conditioning system. Performed thorough inspection of the blower wheel assembly, which showed normal operating condition with no visible wear or damage. Inspected and documented the heavily soiled air filter with significant dust accumulation, indicating need for replacement to maintain proper airflow and system efficiency. All components photographed for service documentation, and system is operating within normal parameters under active MVP coverage through 2026.

Responded to complaint of reduced airflow and insufficient cooling on second floor with 8-degree temperature differential. Inspected outdoor condensing unit and accessed electrical compartment to evaluate system components. Documented internal wiring connections, contactor assembly, and TurboStart capacitor condition for diagnostic purposes and service records.

Completed MVP cooling maintenance visit on residential air conditioning system. Performed comprehensive inspection of outdoor condensing unit, including examination of internal components with front panel access, verification of electrical connections and refrigerant lines, and assessment of coil condition. Unit operational and system functioning properly at time of service.

Completed comprehensive AC tune-up on 12-year-old Trane system that was operating properly upon arrival. Performed standard cooling maintenance protocol including inspection of blower wheel assembly and evaporator coil access, verification of airflow through supply grille, and assessment of interior components for wear and operational efficiency. All system components found to be in satisfactory working condition with no repairs required at this time.