HVAC, Plumbing & Electrical in Cuyahoga Falls, OH

Responded to service call regarding shower valve that would not shut off. Upon inspection of the recently installed shower system in an older home, diagnosed issues with the valve assembly. Performed necessary adjustments to the water control mechanism, ensuring proper on/off functionality. System now operating correctly with no leaks observed.

Performed routine maintenance tune-up on a 2-year-old heating system. Inspected internal components using hex key for access, verified system operation, and ensured all panels and connections were properly secured.

Performed routine heating preventative maintenance on customer's system. Inspected plumbing components and ball valve functionality on heating unit. Checked and verified condition of air filter, noting normal pleated structure with proper support strips intact.

Conducted estimate for replacement of 16-year-old HVAC system. Current installation includes a Carrier humidifier mounted on the air handler with associated PVC drain lines and venting. Outdoor AC unit shows significant snow accumulation and exposure to elements, positioned against brick exterior wall with nearby drainage pipes.

Performed scheduled heating maintenance for MVP customer. Inspected and replaced faulty igniter component that showed signs of wear. System is now functioning properly with all safety checks completed.

Responded to a water leak service request for a 25-year-old home. Investigated water intrusion between floors, focusing on bathroom plumbing fixtures. Identified mineral buildup around sink drain as potential contributing factor. Performed necessary repairs to stop leak transmission from upper to lower level, preventing further damage to ceiling-mounted light fixture in the kitchen area below.

Performed scheduled maintenance on 4-year-old mini-split system. Discovered and removed severely dust-clogged filter which was significantly restricting airflow. Cleaned filter and reinstalled, restoring proper system operation and airflow.

Performed scheduled heating maintenance visit that was previously owed to customer. Inspected furnace system with attached Aprilaire humidifier and noted significant corrosion on copper elbow joint connecting to PVC pipe, showing signs of leakage and mineral buildup. Recommended repair of deteriorated connection to prevent future water damage and ensure proper system operation.

Completed furnace maintenance service as rescheduled. Inspected air filter which showed normal dust accumulation but remains functional. Examined Aprilaire whole-home humidifier system; verified proper installation with appropriate ductwork connections and sealing.

Performed thorough evaporator coil and blower wheel cleaning service on customer's Lennox heating system. All components were properly cleaned and system operation verified to ensure optimal performance and efficiency.

Completed scheduled MVP heating system maintenance service that was previously rescheduled. Inspected plumbing components including the shutoff valve and pipe connections. Replaced filter element (dated 2-5-24) to ensure proper system operation and efficiency.

Performed regular maintenance check on furnace for MVP customer. Inspected metal components and connection points of the heating system. Documented condition of ductwork junctions with photographic evidence for service records.

Completed furnace tune-up service on residential heating system. Inspected heat exchanger and cooling coil components for proper operation. Observed and documented condition of metal fins and internal components, noting no significant issues requiring immediate attention.

Responded to service call for furnace with operational blower but no heat output. Inspected control board and wiring connections, finding loose connections on the circuit board. Reconnected all wiring properly and verified ignition sequence. System now producing proper heat with normal operation of all components.

Performed diagnostic service on 12-year-old furnace exhibiting intermittent cold air issues. Conducted amperage testing with clamp meter on blower motor and verified proper operation of gas valve assembly. System is now functioning correctly with proper ignition sequence and consistent heat output.

Replaced 40-gallon tall water heater with a new 40-gallon short model Bradford White unit, creating necessary clearance for installation of thermal expansion tank on cold water line. Replumbed gas line using 1/2" pipe from the existing 1/2" x 3/8" 90° fitting above ductwork to the tank and installed new 1/2" shut-off valve. Complete installation includes new ball valve and 6-year tank warranty.

Performed scheduled furnace maintenance service for MVP customer. Inspected control board components including DIP switches and terminal connections. Replaced 413 filter and water panel as part of routine preventative maintenance to ensure optimal heating system operation.

Performed camera inspection of main drain system. Utilized power auger to clear blockage in concrete floor drain. Identified water damage and moisture issues in basement utility area requiring further attention. Camera equipment returned to shop after service completion.

Diagnosed and repaired a repeatedly tripping breaker in customer's recently installed panel. Inspection revealed loose connection at breaker terminal causing intermittent short circuit. Tightened all connections, tested circuit under load, and verified proper operation with no further tripping issues.

Performed routine furnace maintenance service as requested. Inspected and cleaned ignition electrode to ensure proper spark ignition. System is operating within normal parameters and no repairs were needed.