Trusted HVAC, Electrical & Plumbing Services in Streetsboro, OH

Replaced existing 80-gallon electric water heater with new 40-gallon Bradford White electric water heater with 6-year manufacturer warranty in basement utility area. Installation included new ball valve, thermal expansion tank mounted to ceiling joists, and all necessary copper piping and fittings to complete the connection. Two-person crew facilitated removal of old unit and proper installation of replacement equipment.

Completed scheduled MVP heating maintenance visit. Performed comprehensive system inspection including examination of ventilation components, louvers, and air intake assemblies. All equipment found operating within normal parameters with louvers and ductwork in functional condition showing typical wear patterns consistent with regular use.

Completed scheduled preventive maintenance on 10-year-old Trane HVAC system for MVP customer. Performed comprehensive inspection of furnace, air handler, and associated electrical controls, verifying all components operational and connections secure. Documented system condition with photos showing proper installation of PVC ventilation lines and control board wiring configuration.

Completed comprehensive AC tune-up on aging Trane 13 SEER outdoor condensing unit (Model 4TTR3030G1000AA) showing significant weathering and over 15 years of service. Performed standard maintenance protocol including inspection of electrical components, fan motor operation, refrigerant levels, and overall system functionality to ensure continued reliable cooling performance.

Completed comprehensive tune-up service on HVAC system, arriving after 2:30 PM as requested. Performed thorough inspection of air handler components including blower motor assembly, control board with electrical connections, and heat exchanger, verifying all wiring connections were secure and system components were operating within normal parameters. Replaced 16x24x1 air filter and documented equipment condition with photos for service records.

Completed full HVAC system installation including new 80% efficiency furnace and air conditioning condenser unit. Installed two outdoor condensing units with proper refrigerant line sets, electrical disconnects with 20A fuses, and established all necessary power connections to exterior electrical service panel. All equipment mounted on prepared pad with proper clearances, refrigerant lines properly insulated and secured to building exterior, and system tested for proper operation upon completion.

Responded to no water complaint in kitchen. Upon arrival, inspected kitchen faucet and verified lack of water flow at fixture. Traced supply lines to basement utility area and located water heater with associated plumbing connections. Assessed water distribution system including supply valves and piping connections. Documented existing conditions of kitchen sink fixture, supply lines, and basement mechanical equipment for service records.

Responded to water leak complaint on 2-year-old natural gas furnace where water was observed discharging from the exhaust pipe. Upon inspection, identified condensate drainage issue affecting the PVC vent piping system. Examined the condensate drain line configuration in the ceiling cavity and verified proper installation of drain components and connections. Addressed drainage concern to prevent water discharge through the exhaust termination. System operational upon completion, with condensate properly routed through designated drain lines.

Responded to service call for faucet installation in laundry room off garage. Customer had shut off the supply valve underneath due to light dripping from the existing fixture. Successfully installed new chrome dual-handle faucet assembly with central spout on white porcelain sink, ensuring proper connections to supply lines and confirming no leaks upon completion.

Completed preventive maintenance on residential air conditioning system. Inspected electrical connections at outdoor condensing unit, verified proper wire routing and terminations, and documented equipment condition. All electrical components found secure with no immediate safety concerns noted, though unit exterior shows normal weathering from environmental exposure.

Conducted comprehensive assessment of 28-year-old furnace and air conditioning system at owner-occupied residence for complete replacement estimate. Evaluated existing Carrier furnace installation, inspected condensate drainage lines, venting configuration, and electrical connections in basement utility area. Documented current system condition including aged refrigerant lines showing corrosion, existing ductwork connections, and overall equipment layout to provide accurate replacement specifications and installation requirements.

Responded to service call for furnace emitting burning odor with visible damaged component. Upon inspection, accessed unit interior and identified compromised electrical component on control board. Documented existing wiring configuration and component condition with photographs showing extensive wire harness network, control board connections, and internal mechanical assembly including blower motor housing and PVC condensate piping. Given household occupant's medical sensitivity to temperature fluctuations, prioritized rapid assessment and provided recommendations for component replacement to restore safe heating system operation.

Completed full HVAC system installation including an 80% efficiency furnace and air conditioning unit for an 858 square foot residential property. The AC condenser was positioned at the rear of the home per the site plan, with the furnace installed in the basement mechanical room alongside existing water heating equipment. New flexible ductwork was installed and connected to the furnace with proper insulation, and all gas connections were secured with appropriate shut-off valves for safety compliance.

Responded to electrical outage affecting approximately two-thirds of modular home that had been vacant for three and a half months. Upon arrival, conducted comprehensive evaluation of electrical system to identify cause of power loss suspected to be related to rodent damage from mouse infestation. Performed thorough inspection of main electrical panel and discovered extensive corrosion and water damage throughout the enclosure. Panel exhibited significant rust accumulation on bottom surfaces and lower portions, with corrosion extending to terminal connections and internal components. Found degraded and discolored wiring with compromised insulation showing signs of aging and environmental exposure. Observed disorganized and tangled wiring in lower section of panel with accumulated debris and particulate matter. Documented conditions with photographs showing corroded bussing connections, deteriorated circuit breakers, and moisture-damaged electrical components. Panel condition indicate

Returned to property to install replacement thermostat on furnace unit that was previously installed approximately two weeks prior. Successfully mounted and wired new Honeywell digital thermostat to wall, verified proper communication with heating system, and confirmed operational functionality.

Performed routine preventive maintenance on residential standby generator system. Conducted comprehensive inspection of unit including visual assessment of gas meter connections, supply piping, and associated fittings which showed signs of corrosion on copper components. Verified generator control panel operation with all indicator lights functioning properly and confirmed unit powers on successfully. Documented existing condition of gas supply infrastructure and generator equipment with photographic records for service history.

Completed installation of new air conditioning system and humidifier at residential property. Installed outdoor condenser unit on prepared mulch bed with proper clearances, ran refrigerant lines and electrical conduit to disconnect box mounted on exterior wall, and installed condensate drain line. System was evacuated to proper micron level as verified by vacuum gauge reading, pressure tested, and commissioned for operation.

Responded to service call for a leaking Rheem Performance 40-gallon gas water heater (Serial # A421906493). Upon inspection, confirmed active leak at base of unit with visible water staining on concrete floor. Evaluated unit per previous diagnosis from another contractor indicating failed gas control valve and pilot assembly. Assessed overall condition of water heater and documented existing plumbing connections including copper supply lines, flexible connectors, and temperature/pressure relief valve. Provided technical evaluation and repair recommendations to customer.

Completed scheduled maintenance flush on tankless water heater unit mounted in basement utility area. Performed descaling procedure by isolating unit with service valves, circulating cleaning solution through heat exchanger to remove mineral buildup, and flushing system thoroughly to restore optimal performance and efficiency.

Completed comprehensive AC tune-up including system inspection and performance verification. Inspected and documented electrical components, including 30-amp FLNR fuses in holder, confirming proper amperage rating and fuse integrity for system protection. All components found operating within normal parameters with no immediate service needs identified.